The equipment has the advantages of simple structure, time saving, power saving than tire repair equipment in general; better hot repair in other cold repair equipment, life is equal to the original tire patch. Applicable to all kinds of specifications models of cars, off-road tires, truck, car, light truck tires and other tools, the size can be, good versatility.
Two wound range:
Nail in the eye,.6 mm.
To.6-10 mm holes
To.10-20 mm holes
To.20-50 mm holes
To shoulder drum kits.
To ensure you can repair tire top 5 cm below, sidewall any wound 10 cm below.
Three. The characteristics of the equipment:
To.1 device can repair almost all the specifications of the car and light truck tires.
You. Fool the machine, simple operation, a look that will be used.
In addition to repair it. The car tire, inner tube can repair large wound.
It is equipped with a toolbox. And tool sets, beautiful appearance, small occupied space
Four. The quality of repair of equipment:
Room temperature vulcanized 4.1. SUPER 12 mm thick vulcanized heating plate 120 centigrade, will not lead to the aging of rubber airtight layer, will not damage the vacuum tire, does not damage the ply layer, good repair quality.
4.2. balloon pressure, curing pressure in place and ensure uniform, patch fitting in place, good quality of sulfide;
4.3. has powerful functions, a set of equipment can be repaired all the car and light truck tires;
4.4. power: less than half a tire vulcanization degree;
4.5. time: about 1 hours a tire vulcanization;
4.6. energy: a person can easily operate, simple and fast;
The quality of 4.7. repair is cold fill more than 5 times but only about 1/10 of the cost of cold patch, can replace the cold patch;
4.8. can repair the car tire repair wound, the quality is consistent with the original tire;
4.9. can repair the wound repair of the inner tube, the same quality and new.
4.10. repair is not affected after the tire dynamic balance.
Five. The main technical indicators
Voltage: 220V AC 50Hz
Vulcanization heating board power: 250W * 2=250W
Cure time: 60-80
Standard curing bladder pressure: 0.2Mpa (2Kgf/cm2)
Efficient vulcanization area: 180mm * 310mm
The best curing temperature: 120 DEG -130 DEG
